Controls Push button (Combi)

Controls Push Button Combi

• Set of controls without the standard aluminium anodized front panel
• Separate On/Off button with Quick Connect/Release Connector
• Use this set when installing Joystick and On/off button directly to a dashboard
• When no Jet Thruster control panel shield is required

All our control panels have the on/off button integrated in the aluminium panel. In case you need to install the controls to a dashboard, helm station or any other place where based upon customer request, or technical situation, no panel is preferred, you can order this dedicated control set.

The set provides an On/Off button which will be connected with a plug&play connector to the controls assembly.

Normally it's impossible to place the soldered-on on/off switch to the dasboard without cutting the original cables. With this set we now offer a situation where the mandatory on/off button is connected to the controls with a quick release connector setup. Simply drill the hole for the on-off button and lock it in place with the provided nut. Connect this switch with the water proof connector and the system will be operational.

Note: Without this On/Off switch the system will not work. Make sure to place the on/off switch near the push buttons, and verify cable lenght prior to drilling.

Before you order it's important to check which electrical Jet Thruster circuit you have in order to select the correct part.

With use of these drawings can can verify this.

Procedure:

- Remove the black plastic cover from pump unit and verify you have similar electrical connections like the below mentioned drawings before you order this control panel